Patch addressing high temperature issue + better airflow to sensor (Particulates Sensor Case for Luftdaten.info)

thingiverse

This is an improved version of the original project Particulates Sensor Case https://www.thingiverse.com/thing:2775946. A superior design for luftdaten.info / sensor.community particulates sensors, built around OBO Bettermann T60 junction box.\r\n\r\nIn my previous remix https://www.thingiverse.com/thing:4337435, I addressed the airflow problem, but temperature readings remained too high because DHT22 sensor was placed inside of the box. The only effective way to get accurate temperature measurements is to place the DHT22 sensor outside of the box.\r\n\r\nBy adding this extra part to the original project, it greatly improves fresh airflow to the sensor and allows you to place the dht22 sensor outside of the OBO Bettermann T60 junction box for precise temperature readings.\r\n\r\nA similar approach can be found here https://www.thingiverse.com/thing:3841481, but I preferred to stick with the original project and like the OBO Bettermann T60 junction box more than the Hensel DK0400G, which is also more expensive than T60.\r\n\r\n\r\n- Please note that the tolerance between this part and other original components is 0.10mm. The components will fit very tightly and it may be difficult to remove them.\r\n\r\n- As for the DHT22 sensor's box, you can use https://www.thingiverse.com/thing:4360466 a remix of https://www.thingiverse.com/thing:1520129 or other similar cases. Of course, this is not meant to be placed in direct rainfall! \r\n\r\nIf you have any thoughts, hit the comments link above.