Particle Argon

thingiverse

I designed a Particle Argon model so that others can design a case around it if needed. Importing this model into their own 3D work allows them to confirm its fit in the desired location and where to place struts for support. The holes on this model are dimensionally accurate based on the Particle website information. I included the JST connector, USB connector, and any other elements that might interfere with the design. When designing a case around it, I leave 0.25mm or 0.375mm clearance outside to ensure a snug but not tight fit. This model was revised and re-uploaded on December 1st, 2019 to correct an error in pin placement. I measured my Argon with a vernier caliper as accurately as possible and believe the new pin placement is improved over the previous version.