Partcooler for FT5 Aero setup with E3D V6

thingiverse

This is a partcooler for this setup: http://www.thingiverse.com/thing:2268567 I don't have a V6 anymore and won't test this. It should be similar to the Volcano design mentioned, and it should work fine. If you encounter any issues or have comments, please leave them below. You will need the following parts from the Volcano design: - Belt plug: print two times with a 0.4mm nozzle due to the details - Aero top: sits on top of the carriage - Aero front design: front panel - Aero bltouch support - Aero back with blower support: back panel with integrated support for a 50x50x15mm blower - Aero blower outlet: connection piece between back and shroud All parts can be printed with a 0.6mm nozzle, or smaller if desired. I used layers of 0.32mm and 0.4mm, with three bottom and three top layers, 50% infill, and five walls. The blower shroud should be printed with a 0.4mm nozzle. However, I could redesign it with thicker walls if there is demand. I'm not affiliated with the shop, but all parts that are near the hot end or can become hot are now printed in 3DK-Top heat-resistant material. It's available at http://3dk.berlin/en/26-3dktop-heat-resistent and works well up to 200°C. 20170902: Upon request, I made a version with more space between the hotend and the right leg of the shroud. Look for the file "Aero V6 shroud wider on the right.stl". I highly recommend printing this in ABS. 20171007: Upon a remark about mesh issues, I made a thicker version marked V2. I checked it for mesh defects.