Parrot Bebop 5mm Prop Adapter

thingiverse

I designed this adapter specifically for using standard 5mm drone propellers. To match motors spinning clockwise, simply use CCW threads, and vice versa for motors spinning counter-clockwise - use CW threads. The nut itself is threaded clockwise; for the counterclockwise application, merely mirror the print in your slicer to produce a reverse-threaded version. To install the new adapter hub, first remove any existing propellers. Then, take out the three screws that held the old propeller in place and use them to secure the new hub down. These prints work well with PLA at 100% infill and fine resolution settings. However, they might be a bit tight, so you may want to consider using an M5 steel screw to loosen the threads slightly or upscaling your print by just a fraction.