Parrot Bebop 2 Propeller Case

thingiverse

After purchasing a Parrot Bebop 2, SkyController and official Parrot Bebop backpack, I encountered a significant issue... The drone wouldn't fit in the backpack with the props attached, and there was no suitable way to store them inside the backpack. After using the container that replacement props ship in and even the sunshade as a protective measure, I decided to design this solution.\nThe case is robust and thick with ample space for 4 propellers, allowing them to slide in and out easily without getting stuck or warped. Although not airtight, the lid prevents large debris from entering and is thin yet reinforced to prevent warping. The tabs at the ends of the lid keep it in place, relying on FFF printing to secure it properly.\nThe box features small cutouts along the top edge, enabling you to pry the lid off using your fingernail. Nothing overly complex was involved in its design.\nPrint Settings\nPrinter: Da Vinci 1.0\nRafts: Not Required\nSupports: None Needed\nResolution: 0.4mm\nInfill: 15% Density