Parrot Anafi Battery Cover

thingiverse

I made this remix from https://www.thingiverse.com/thing:3100838 My appreciation for the good idea with the snap-on part. My changes are as follows: - No fonts on it, so you can print it in a printer-friendly position (openings upwards) and no supports needed - The upper side is slightly rounded - I made my own measurements of the connector part and modified the recesses for easier snap-on and best fit (bigger tolerances) - If needed scale it up/down a bit (0.5%) because different printer tolerances; the width of the block is exactly 26mm - Made of PLA Edit 1/12/2018, v2.1: The only difference the click-in part is a little bit harder; doesn't matter in most cases because I have no feedback that the first version is too loose