Parkside Compressor - Air Filter

thingiverse

This is a replacement part for Parkside and maybe other brand Air Compressors. This is the air filter part. The 4mm threaded screw is needed. It needs to be heated before being screwed and fixed to the bottom part (no, I don't want to put a nut inside the air intake of the compressor!). V2: No screws or anything else are needed anymore. The threads seem good but need to be mounted. V3: Corrected threads were added, and 10mm was added to filter mount thread. A friend having broken his air filter support on his Parkside Compressor asked me to remake one for him. A 4mm threaded rod is necessary. It must be heated to screw it into the lower part. Much safer than putting a nut inside the air intake of the compressor! V2: No threaded rod or anything else is needed anymore. The thread seems correct, but I haven't been able to mount it yet on the Compressor. V3: No vis correction between the cap and the filter support was made. The foot threads were extended by 10mm because this air filter support is a bit wider than the original one and forced into place slightly (the black housing hole was too small, but it fit anyway).