Parkflyer 400 GT

thingiverse

A highly agile copter designed to handle propellers up to eight inches in diameter is now available. The components required for this build can be found at https://www.parkflyer.eu/store/400-gt-parkflyer/. Building instructions will follow shortly. Update: - A manual has been added. - The middle screw channel on the top center plate has been slightly reduced, allowing common 4S LiPo batteries to fit better in the battery compartment. (400GT-topplate-center_V2.stl) Recommended setup includes: 1400 KV motors 20 amp ESCs 4s LiPo batteries with a minimum capacity of 2400 mAh (3S recommended) 7-8 inch propellers Canopies can be found at https://www.thingiverse.com/thing:2335529 and https://www.thingiverse.com/thing:2335535. The screw-set frame requires the following components: M3 x 50 mm hex screws, eight pieces M3 x 10 mm rivet nuts made of aluminum, eight pieces M3 x 30 mm hex screws, four pieces M3 x 10 mm hex screws M3 locknuts, six pieces Flat washers for M3 screws, twenty pieces The motor mount flat requires: M3 x 25 mm hex screws, sixteen pieces M3 x 20 mm hex screws, four pieces M3 nuts, twenty pieces Flat washers for M3 screws, forty pieces The motor mount raise requires: M3 x 25 mm hex screws, twenty pieces M3 nuts, twenty pieces Flat washers for M3 screws, forty pieces Arms and landing gear require: Carbon tubes measuring sixteen millimeters in diameter by two hundred fifty millimeters long, two pieces Carbon tubes measuring six millimeters in diameter by fifty-five millimeters long, four pieces