Pardini SP 22LR 6 shot magazine

thingiverse

Pardini SP 22LR Magazine Upgrade This upgrade enables you to load six cartridges into the Pardini SP magazine, meeting the requirements for certain shooting competitions in Scandinavia that demand a six-cartridge magazine. This non-destructive modification was designed to enhance the magazine's functionality. Before starting, ensure your printer is properly calibrated and slow down the print speed (I used 30 mm/s). Printing with PLA is not recommended due to its inadequate heat resistance; instead, use ABS for optimal results. The Ender 3 should handle these prints without an enclosure, but apply ABS juice and brim to prevent warping. When printing, orient all parts as shown in the fourth picture for accurate fitting. After completion, carefully remove all support material, focusing on the bottom plate where the magazine body slides into place. Conduct a test fit of all components before assembly, trimming parts if necessary. Apply a small amount of gun oil to the bullet follower before final assembly. Please note that this upgrade is done at your own risk; I disclaim any responsibility and liability for damage caused by its use or installation.