Parametric T-Slot Antenna

prusaprinters

<p>This is a generator for clips to build directional antennas with aluminum extrusion (T-Slot). It was designed to allow quick prototyping for Quick2Space, check out their project page here: <a href="https://bitbucket.org/Quick2space/433mhz-antenna/src/master/">https://bitbucket.org/Quick2space/433mhz-antenna/src/master/</a></p><p>It generates one dipole clip and N rod (director/reflector) clips in a set, ensuring the rods are in the same plane with the dipole, iow the same distance from the aluminum extrusion</p><p>It uses a single screw (typically M3 for 15mm extrusion) to both tighten the rod and attach to the T-slot.</p><p>It prints as is, no supports required.</p><p>The included STL example is for 1515 (MakerBeam XL) and 3/16" rods, and uses M3 10mm screws, but you can "Open in Customizer" and adjust as needed.</p>