Parametric Print+ Headphones: Mendel Edition

thingiverse

**UPDATE:** Identified the Customizer was getting confused by the Global variable tab, which has now been corrected. To assemble the custom Print+ headphones, follow these steps: 1. Generate two Cups (one Left and one Right), two Cushion Holders, and one Headband using the OpenSCAD design. 2. Print out the Cups & Cushion Holders with 2 perimeters, 2-3 top and bottom layers, and 15 - 30% infill. You may need to add simple supports for bridging. 3. For the headband, use 2 perimeters and 15% infill to keep it flexible while still maintaining some strength. 4. After printing, tidy up any holes or blobs that came out messy during the print process. 5. Insert a nut into the rod connector at one end of the headband, which will allow for adjustments once everything is assembled. 6. Screw in the threaded rods through the cups and the nut inside the headband. Make sure to align them properly before tightening. 7. Add a washer down the top of each threaded rod, followed by a nut, to keep the rod from spinning too much. 8. Tighten the second nut against the washer for added stability. 9. Assemble the headphones in the same way as the original Print+ headphones, threading the L/R connecting cable through the headband first and then into each cup. 10. Position the PCBs, connect the L/R cable, Cushion Holders, and finally the cushions themselves. 11. If necessary, adjust the position of the cups once everything is assembled by loosening the nut(s) at the top of the threaded rod and spinning the captive nut to move the rod up or down. Note: The buildplate option has not been implemented yet, so you will need to generate the STLs manually.