Parallella Vesa Mount

thingiverse

Using your Parallella is more fun without it hogging valuable desk space.\nThe mount for the Parallella perfectly attaches to any monitor, following the industry-standard Vesa mounting system. The customizable M3 screw holes on this mount seamlessly integrate with both the original Parallella board and its compatible cases, ensuring a sturdy hold.\nBoth 75mm by 75mm and 100mm by 100mm Vesa standards are supported.\nParallella Board: http://www.parallella.org/\nLearn about Vesa Mount Standards here: http://www.mountcenter.com/VESA-Mount-Standards-s/367.htm\n \n \n Setup Instructions for your printer\nSuccessful prints of a Vesa mount use these printing settings:\nExtruder Temperature: 215c Base Temperature: 55c, using painters tape Infill Density: 30% Type of Plastic Used: PLA Printer Model: Makerbot Replicator Dual Extruder