Paperclip Zipper pull tab

thingiverse

I made this for my own backpack after finding a zipper slider on here (also shown pictured) and printing it. I used the idea of a paperclip from some other models I had seen. This used no screws or glue and simply snaps together. Using a soldering iron on the edge is great as it makes this build stronger. To use: Scale up or down according to your paperclip size. Then hook the paperclip onto your slider and put the paperclip, lying completely flat, through the small hole on the side of the bottom piece. Make sure the paperclip's loops are around their circle (you may need tweezers to get it fully down). Then snap the top on and you are done. Tip: This may not work with a clip that has a coating on it as the clip may not fit through the small gap. I hope this makes some ones life just a little easier!