Paper Towel Roll Holder

thingiverse

Print two sets of the third-revision design on the left in the images. Each set should comprise of two holders. These holders are designed to accommodate rolls with a maximum diameter of approximately 130mm. They can be attached to various surfaces, such as under cabinets, on table tops, back walls or side walls, and even at arbitrary angles. To ensure accurate spacing between the holders, use the actual rolls you will be using as spacers. Attach each holder to a desired surface using a moderately thick VHB tape (which adheres well to PLA). The roll holders can be flexed slightly for easy insertion and removal of rolls. Note that from Version 2 to Version 3, the design was modified with a larger radius at the mounting to upright and a much shallower part sticking into the roll.