Paper stand, paper holder

myminifactory

Print at a 0.2 mm layer height for optimal results, though I used a 0.3 mm setting to speed up the printing process - and was pleasantly surprised by the outcome. However, be cautious when positioning the stand on the print bed due to the overhang (5 mm) near the bottom where the pusher is attached. Fortunately, my Ender 3 handled this overhang without issue. To achieve the best results, secure the pusher in its slot using superglue. The attached files include a 38 mm wide pusher design, while the images show how I created two 13 mm wide pushers with a 12 mm spacer between them (13 mm + 13 mm + 12 mm = 38 mm slot width). If you decide to print this model, be sure to share your photos in the comments.