Paper hand towel dispenser

thingiverse

I printed this using a 0.8mm nozzle and 0.4mm layer height at 100% infill on a modified direct drive Ender 3. It nearly fills the entire build volume completely. No screw holes were included; you'll need to add them according to your screw size requirements. This design is intended for tri-fold paper towel stacks, which are approximately 235mm long x 85mm wide when folded. After printing and removing support material, make sure the dispensing slot is free of jagged edges and smooth. I used a torch to soften the material and round out the edges very smoothly. If you don't smooth these edges, towels will be difficult to pull from the dispenser; once smoothed, you'll get one towel per pull every time without any issues.