PanelDue holder and swivel box

thingiverse

Changelog: - Added detents, which resolved weight issues with the panel. It was initially sufficient, but surfaces wore in over time, causing the panel to sink. Detent added to Front panel and Display box. PanelDue case for 5-inch version features a small box that allows the display to be rotated. It's designed for mounting in a coreXY with a heated chamber, facing the front. A cutout can then be made in the door. The case has a finger tab for rotating it out. Firstly, force the Front part into the Display box, using the two hinge points at the top. Some force is required. The Paneldue is mounted inside the Front panel with 1 screw for the control board and 2 screws initially to hold it in place. Ensure you slide in the reset button first if desired. The Control lid clicks into the Front panel with two cutouts, then use two M3 screws to secure it down. The Back lid slots in and clicks into the Front housing, secured with two M3 screws that clamp the PanelDue tightly as well. In the Display case, there are two little loops guiding wires to the bottom. Screw holes have not been included in the Display case as mounting options depend on individual preferences. A reset button is provided; slide it in from inside out and glue the top button on. An Erase button has not been included, but a tiny hole guides a paperclip to the switch. A second box has been added, this one closed on all sides except for the front. Photos of first quick prints have also been added. The STL models have been checked and optimized. Parts requiring different orientations for proper printing are rotated to preferred positions.