PanelDue 7i case for E3D ToolChanger (centered)

thingiverse

This is a remix of a design I created two years ago for my BigBox (thing:1828099). I made this design because I wanted to place my 7inch screen in the middle of my E3D Tool Changer, but current designs are asymmetric due to the PanelDue controller board being mounted directly to the backside of the screen. To resolve this issue, I designed a bracket for the controller board that must be screwed at the back of the screen. A 40pins (IDE) cable is then used to connect the two, requiring some soldering (see pictures), since the connector pins are sort of mirrored on standard 40pins connectors. With the two feet mounted, you can slide the case onto the bottom plate of the printer. The design can be printed without supports. Parts used: 9x M3x6 hex socket self-tapping screws 1x 20cm 40pin GPIO Ribbon Cable 2x 40Pin 2.54mm male single row header strips