PanelDue 7" LCD Enclosure Ultibots K250

thingiverse

This enclosure is designed specifically for the PanelDue with 7" LCD that mounts to the bottom frame 2020 extrusions on my Ultibots K250 Delta printer. It slopes the face and makes it perfectly height-adjusted for using from a desk chair in comfort. The front latches securely to the back for quick access to the Panel Due. This design is adapted directly from DC42's PanelDue enclosure. Instructions This was designed specifically with the Ultibots K250 in mind, so I'm unsure if the 300 has the same 2 sets of 2020 extrusion for the bottom frame or the correct height. After careful examination, I found that I only needed to use the top 2 holes and attach to the top 2020 extrusion. Additionally, I had to orient the large pieces with the long direction pointing directly away from a tower on the K250 with UMBE to avoid a mag ball rod coming loose. There are two distinct Panel Due Front STLs available: one with integrated tabs and one without them. There are also STLs for the tabs and latch only, allowing users to print each component separately. This approach enables users to print the front with a larger nozzle and layer height while printing the tabs with a smaller nozzle and small layer height. Printing them separate gives the correct "grain" for the tabs. If printing separately, users will need to bond the tabs to the front using a suitable adhesive, such as JB Weld. Some filing may be necessary on the back where the tabs and latches go for a good fit. Alternatively, users can try resizing the tabs and latches slightly smaller. To facilitate assembly, I held the front and back together with tape or rubber bands while reaching through the hole for the LCD to position the tabs and latches.