PanelDue 5i Mount for Wanhao D6, Monoprice U3

thingiverse

UPDATE: - Switched from side mounting holes to slots for easier assembly. Simply start the screws and drop the bezel down onto them. Tighten them up and you're ready to go! - Found that the bezel was touching the screen causing odd behavior, so I expanded the opening and moved it away from the surface. This is a front mount bezel designed for the PanelDue 5i used in Wanhao Duplicator 6 or Monoprice Ultimate 3 printers. It's low-profiled and matches the curve of the chassis for a sleek look. A door can still be used, but the front edge will need to be raised about an inch with some sort of riser - I use these: https://www.thingiverse.com/thing:3417554. Two versions are included - one without SD card access and one with. **Note: You'll need to remove the stock LCD and Knob**, then secure them together with M3 SHCS and nuts using two mounting plates, one inside and one outside the chassis. Secure the PanelDue in the bezel with M3 screws. **These mount holes are deliberately small - use a 4mm M3 or put nutserts in them**. Attach the ribbon cable or 4-wire cable and route it through the rectangular hole in the mounting plates. Secure the bezel to the front mount plate with M3x4 or 6 flat head screws into nuts. There are many screw holes in the mounting plates, but you don't have to use them all. I countersunk for flathead screws on the sides of the bezel, but socket heads can be used instead. Overall, I'm happy with it - it's sturdy and thin, allowing me to reach the edges of the touch screen easily. I might print it again for better quality (the pics aren't great). The mounting is probably over-engineered, so feel free to remix and improve on it - just let me know!