PanelDue 5i mount for RailcoreII

thingiverse

I'm currently revamping the design to move the mount upward slightly so that it's door-compatible. The updated files should be available online by mid-May 2019. This is a straightforward project for the PanelDue 5i on a RailcoreII printer. The case back features two sets of holes, allowing you to mount the display as shown or position it higher to accommodate a door over the front opening. You'll need six tapered M3 heatset inserts (available from McMaster or an alternate source) to secure everything in place. Be cautious when removing the case front from the printbed, as the reset button can break off easily. Before mounting the back panel on your printer, make sure to route the wires through it. There's sufficient clearance between this housing and the Railcore for cables, but not enough room for connectors after it's installed.