Panasonic 42.5mm f1.7 Lens Hood

prusaprinters

<p>This is a lens hood for the Panasonic 42.5mm f.17 micro four thirds lens. The mount snaps in place like the real lens hood. It is a little tricky to take off the first time (just like the real ones) but loosens up pretty quickly. It isn't reversible.</p> <p>The print with the rough surface was done using Cura's Fuzzy surface experimental option and a support blocker to make sure it only printed on the hood part.</p> <h3>Print Settings</h3> <p><strong>Printer Brand:</strong></p> <p>Creality</p> <p class="detail-setting printer"><strong>Printer: </strong> <div><p>Ender 5</p></div> <p><strong>Rafts:</strong></p> <p>No</p> <p class="detail-setting supports"><strong>Supports: </strong> <div><p>Yes</p></div> <p><strong>Resolution:</strong></p> <p>.2mm</p> <p class="detail-setting infill"><strong>Infill: </strong> <div><p>25%</p></div> <p><strong>Filament:</strong> eSun PLA Black</p> <p><br/> <p class="detail-setting notes"><strong>Notes: </strong></p> </p><div><p>It took some trial and error to get all the sizes right and printer settings may throw it off. I printed mine on an Ender 5 Pro sliced in Cura 4.6. The important settings were:</p> Print with the bottom down. <p>0.2mm Layer Height</p> <p>0.4mm Wall Line Width</p> <p>3 Wall Line Count</p> <p>25% Infil.</p> <p>Supports Enabled</p> <p>Horizontal Expansion: 2 (This setting wasn't shown by default but it wasn't generating full supports without it).</p> <p>This was printable without supports but the fit was way better with them and the amount of supports needed are minimal and only in the first layers.</p> </div></p></p></p> Category: Camera