Pan, tilt and roll camera pod for FPV.

thingiverse

EDIT - 06.01.2016 Added a plate for a single cam to roll with Mobius action camera mounted atop. EDIT - 27.01.2016 I added a plate for a solo cam using Roll03.stl. A pan/tilt/roll camera mount is designed specifically for two Sony CCD cameras measuring 1/3 inches in diameter. The mounting platform may need adjustment to fit your individual camera or use rollblank.stl as the base to create a customized plate from scratch by uploading STL files into CAD software. Double-sided tape will hold my cam firmly in place. Hitec HS-225MG/BB and HS-65HB servos guide the design, allowing flanges to be used directly without requiring further adaptation. For completion, a single 3x10x4 mm ball bearing, an M3x12 screw, and self-tapping screws (minus grommets) for servos are necessary. Print Settings: Supported Features: Support Not Needed Note: To achieve optimal results print with extrusion widths of 0.5mm or smaller, using a layer height not exceeding 0.2mm to produce flanges without flaws. Tilt section bridges should be bridged, and the piece printed open; support structures weren't necessary in any part's print process. The initial bridge may be slightly messy, trimming as needed for desired results