Palm Tree Lamp

cults3d

#FLASHFORGECULTS Normally when I am getting ready for bed, I turn the light off and use my phone to get into bed. I then end up using my phones flash light to continue doing everything that I should have completed while the lights were on. This becomes a problem when I need both hands to move/do something. A simple solution would have been to go out and purchase a lamp for the side of the bed. Creating this lamp stand was the solution I ended up going with. You can place your phone in the top part, turn on the flash light and use it as a lamp. It also doubles as a charging port. There is a hole through the entire base of the lamp stand that a standard apple cable can fit through. When it comes out of the base, there are 3 directions of which the cable can be located to be plugged in. This lamp stand is also modular. You can add/remove the trunk parts to your desired height. In between each piece of the trunk, I placed a spacer. This made it so I could super glue it all together easier. The current design is set up for an iPhone 12 Max Pro with a standard 6 foot Apple charging cable. Filament used in the photo: Base: - Inland Bone White (PLA+) Trunk: - Inland Brown (PLA+) Leaves: - Inland Green (PLA) Printed on CR-10S Order of the trunk from bottom to top goes: - Trunk(1) - Trunk (2)_Extendable - Trunk (3) - Trunk(4) - Trunk(5) - Trunk (6) Tips for printing: - Phone holder: Use support blockers for the circular areas that don't need the support. They are tough to get out from the inside where the cable drops down through. #FLASHFORGECULTS If you like what I do, feel free to check out my page, see my other available files and if you feel inclined, use my donate button to buy me a coffee to keep me going!