Palette 2 Stand - Upside Down

thingiverse

I really wanted to place my new Palette 2 Pro on top of my printer enclosure with ease. The problem was that I needed the filament to be positioned behind the Palette 2, so I could easily access the Palette 2 screen without any hassle. Having seen that the firmware update allows the Palette 2 screen to be rotated 180 degrees, I decided to remix the Palette 2 stand so that the Palette 2 could be placed standing up, but upside down for better accessibility. When you mount the stand upside down like this, it naturally wants to slide right off. But fortunately, the fine folks at Mosaic added a hole on each side of the back of the Palette 2, which proved to be very helpful in this situation. So, I added a matching hole to the stand to make sure it stays securely in place. I used an M3x8 screw on each side, which is perfectly tight for the holes without being too loose or too tight. It's essential to only use screws of 6mm or 8mm - not any longer, for fear of hitting something inside that could cause damage. Finally, if you like, you can take the rubber feet from the stock stand and use them on this one for added stability and comfort. Parts Required: 2 - M3 6mm or 8mm screws