Palette 2 Simplified Upside Down Wall Mount

thingiverse

This is a simplified version of Crussty's Palette Pouch that prints in two pieces (four if you opt for a swing collar) and takes less time to print. No support is required. The Palette 2 sits snugly inside the base, while the collar wraps around the upper section just before it starts tilting - right over the palette logo. There are two types of collars available: a solid one and a 'swing out' version. The swing out design makes it easier to remove the device when clearing jams or issues. It's held together with M3 bolts that serve as pins. Simply release one pin, swing the arm free, and you're good to go. To assemble the swing out version, tighten the bolts first, then ensure it rests flat against the wall. Mark the screw locations, remove the front swing, and screw in the side brackets. Finally, reattach the front swing. This design works perfectly with or without the Palette cover!