Palette 2 (S)PRO) Adapter for Artillery Sidewinder X1/Genius

thingiverse

I upgraded my original adapter (thing:4009475) with a taller design and added support for the Palette Bowden tube. This modification is specifically for the Mosaic Palette 2 (Pro) and Palette 2s (Pro). I printed this updated adapter in PLA using the large diameter on the build plate, with 100% fill and Tree Support. To install: Gently pull out the white guide tube from the extruder pressure lever. Slide the Palette 2 adapter into the top slot on the fan side of the lever. Insert the guide tube back into the extruder pressure lever from the top, pushing it all the way down until the top of the tube aligns with the flat surface of the middle hole of the adapter. The tube secures the adapter in place. You may need to trim the guide tube if yours is a little too long. This will prevent it from rubbing against the extruder gear and ensure it doesn't interfere with the rubber grommet and Palette 2 tube. Attach the grommet if you haven't already done so. You'll probably have to sand or file the part of the adapter that slides into the pressure lever to get a snug fit. I was able to install it without removing the lever, but make sure the holes line up before inserting the small guide tube. To remove the adapter, you'll need to detach the lever and push the guide tube out. Don't worry – you can still print without using your Palette 2 guide tube.