Paintball Marker Setup Wall Mount

prusaprinters

<p>This paintball marker setup wall mount was designed with the intention of being both simple and easy to use.</p><p>Simply print both pieces out of high-quality PLA and then do the following:</p><ol><li>Mount the large tank holder to the wall using drywall anchors (use the screw holes in the tank holder as a guide to mark the positions for the anchors)</li><li>Hold your entire marker setup with the tank resting on the tank holder you just mounted</li><li>Mark where the small barrel holder should go by resting the barrel on it, leveling the setup, and then poking two small holes in the wall through the barrel holder holes with one of the screws for the anchors (an extra set of hands may be helpful for this)</li><li>&nbsp;Mount the barrel holder to the wall using drywall anchors</li></ol><p>Print Settings: 20% grid infill, 0.2mm layer height, no supports</p><p>Drywall Anchors (Any anchors with #6 screws should work): <a href="https://www.homedepot.com/p/E-Z-Ancor-Twist-N-Lock-50-lb-Self-Drilling-Drywall-Anchors-with-Screws-6-Pack-11353/100171703">https://www.homedepot.com/p/E-Z-Ancor-Twist-N-Lock-50-lb-Self-Drilling-Drywall-Anchors-with-Screws-6-Pack-11353/100171703</a></p><p>*NOTE* You'll need at least 7 anchors (4 for the tank mount and 3 for the barrel mount) so the 6 pack above will not be enough unless you buy 2.</p><p>Please note that I have never printed these out of a material other than PLA and there may be better print settings. I am not sure if the tolerances are compatible with the slight shrinkage of PETG or other materials.</p>