Painel Auxiliar Impressora Ender 3

thingiverse

The project is intended for the following features: 1°- Turn off the 3D Printer and/or sound alarms when the 3D Printer is positioned at the end of a printout. Note: When you finish 3D printing, there may or may not be an audible warning or/or may not turn off the 3D Printer. Another external alarm can be installed away from the Auxiliary Panel by a long wire if necessary. It can be activated even when the table is still being heated to start a printout. The external alarm can be replaced by any other device powered by 12VDC and still be able to activate a third alarm or equipment as well. 2°- Turn off the 3D Printer and sound an alarm if you finish the filament in use. Note: Once the filament is finished, printing can be continued after installation or splicing of another filament in the filament that is left. In this case, do not sound a second alarm away from the Panel. 3°- Turn off the 3D Printer and sound alarms if the temperature reaches a predetermined limit. Note: The temperature sensor should be positioned in a place that you think should be measured there a maximum limit temperature (try positions and limits) instead in order to inhibit accidents that allow a fire to start. Same conditions for the external alarm as in the 1st Feature. 4°- Turn the 3D Printer off and back manually without turning off the Auxiliary Panel. Note: Whenever the 3D Printer is turned off while printing, when it is reconnected, the question is automatically asked whether or not you want to continue printing interrupted. 5°- Two separate keys to manually turn 12VDC working devices on or off. Note: These appliances can be spare fans installed by you for exhaust or cooling as needed and/or special lighting such as LED's tape and/or 12VDC lenses for the activation of other more powerful appliances such as an additional resistance for rapid heating or high temperature maintenance on the table and etc... 6°- Facilitate access to the adjustment of the print table, especially the rear adjustment of the right. 7°- Allow virtually anyone with a 3D Printer to be able to assemble this project safely and efficiently no as far as your knowledge in electronics may be.