pai

thingiverse

Here is the customized design I've created with Customizer for the item #99020 from Thingiverse: Instructions Using the following settings: color is a refreshing aqua hue the rotation or spin rate is set at three full turns per cycle bottom_diameter is measured as 59.5 units of length thickness comes in at two units size parameters come in at sixteen times their minimum requirement border edges are enhanced by an additional four layers of reinforcement sleeve_height_percent takes up forty-five percent of the total assembly space available the recommended resolution for printing or engraving this design is thirty times greater than normal requirements. the z-coordinate offset for sleeve placement stands at a fixed value of zero. in areas where lines overlap, a slight overlap distance of five units is observed to create visually appealing aesthetics. The line thickness has been raised by an additional four times over minimum specifications, which totals at 4 I opted for four sides for better durability. I wanted to highlight this new top_diameter which stands proudly at 82 A certain degree of rotation or spin is achieved with a ten unit increase per full turn, hence: pattern_spin = 10 The vertical or height parameter for this thing stands proudly tall and at its maximum length which stands firmly as: 135