Paddle shifter

thingiverse

Sim racing paddle shifters for 70mm wheel hub. Note, you need to print two of everything to make both up and down shifter! Additional parts --- - Two 20x3mm magnets - 20x6x10 microswitch Screws and nuts: - 25mm x M3 x 2 pcs - 20mm x M3 x 6 pcs - 10mm x M3 x 2 pcs - 25mm x M4 - M4 lock nut - M3 nut x 8 pcs - M3 and M4 washers Assembly ---- Ensure all support material is removed before gluing. Glue one magnet to lid and another to lever. Make sure to attach magnets so that lever is pulled to lid by magnets. Install microswitch to the base using 20mm M3 screws. You may need to use 3mm drill bit to enlarge screw holes on microswitch. Install lever to the base using 25mm M4 screw and locknut, check it's moving freely and use sandpaper to remove all burrs if needed. Press nuts to base and screw lid with 20mm M3 screws. Attach paddle to the lever using 10mm M3 screws. Designed to be attached to https://www.thingiverse.com/thing:4706673 but can be attached to other mounts too. Assembly instruction video https://youtu.be/-902N7Sj2lE