P60 drop-in mount for quadcopter.

thingiverse

A Custom Housing for E-Liquid Vapes. This holder was created as a basic foundation for adding interchangeable e-liquid tanks. While it works perfectly well in its current state, I have observed areas where significant improvement could be achieved. Following initial construction, it became evident that not all tank inserts were identical in terms of their diameters. Upon taking precise measurements of one tank and then carefully fitting it to another, additional modifications needed to be done using a Dremel tool in order for the tank insert to smoothly fit inside. Utilizing transparent polycarbonate sheets proved to be an excellent method in constructing a front panel designed to protect both LED lights and the reflector underneath from potential damage. It is also recommended that adjustments or additional components may need to be integrated into the vape's e-liquid module to either minimize the heat produced or to fabricate an external DIY heat sink capable of effectively absorbing heat generated by the brass cylinder in the back. The drive mechanism has now been relocated outside.