P51 3 Piece Slingshot Airplane With Trigger

thingiverse

*IF THE DOWNLAOD ALL LINK GOES TO 404 - THEN CLICK THE STL FILES TO DOWNLOAD THEM INDIVIDUALLY* This is the 3 piece P51! It is a 3D printed, flying and slingshot powered airplane! Adjust the tabs on the elevator up or down to raise the glide path up or down. The rudder can be adjusted left and right and the ailerons on the wings control the roll of the plane. Watch a short video with some flights here: https://youtu.be/N_HKZlV5J_U Add a M3 16mm bolt and three lock nuts to the front for balance. Two more M3 16mm bolts and lock nuts finish the trigger unit. With a rubber band under the P51's nose the plane will be held securely in the trigger while pulling the rubber band taught, Squeeze the trigger and flight should happen... If the plane rolls left - then either move the rudder to the right OR move the ailerons in opposite - the left one SLIGHTLY lower and the right one SLIGHTLY higher. This will make the plane roll to the right if you do too much. If the plane climbs up and stalls then push the elevator SLIGHTLY lower. Make sure both sides are even. The opposite also applies... Have Fun!