P-Cube Subwoofer foot for zk-TB21 Amp

thingiverse

A foot for the P-Cube Subwoofer with enough space to put a ZK-TB21 2.1 Bluetooth amplifier in. Replaces the lower end plate trim - the sub is simply placed on top. The small M2 ´feet´ provided with the amp are supposed to be screwed in the baseplate to hold the amp. No specific requirements for filament or printing as this piece should have no influence on acoustics. The design consists of more pieces than perhaps necessary to allow smooth printing - you can just stick them together and leave everything as it is (which I did), alternatively a few drops of glue in the joints should suffice. Printing orientation: back/front/side : the straight inner side is to face the print bed inner : with the big plate touching print bed outer : upward down, so the print gets wider further away from the print bed Knob : - Please let me know if something does not work as intended - I printed it once and was satisfied without further refining it. ~edit~ my version had thermal problems - so I added v2 which is 1cm higher to allow for better cooling