Overwatch display stand

thingiverse

This was designed to complement the soldier 76 helm that I printed for my display case. The main base was printed in gray PLA with the logo printed both in white, and the top little bit spray painted orange. They were designed to slot into the main base with the orange part glued firmly in place. The main part of the logo is a bit tricky to put in, requiring you to bend the middle bit vertically to clamp over the main stem on the base, and due to the tight tolerance of the image, I didn't need to glue it down. Then, I attached a rare earth magnet to the stand and the helm (stacking them up if necessary to keep it in place properly). Alternatively, I could have simply glued the helm straight to the stand. Print Settings: Printer Brand: Ultimaker Printer: Ultimaker 2 Rafts: No Supports: Yes Resolution: 0.2 Infill: 25%