Overlord Cherry MX Holder for manual calibration of bed

thingiverse

This small gadget can come in handy during manual advanced leveling procedures http://www.dreammaker.cc/forum/viewtopic.php?f=6&t=163\nI created it because \nI dislike using the paper method \nIt saves me from taking apart the hotend whenever possible\nYou simply need to remove the stock layer fan's screws and temporarily elevate it higher\nThis gadget can be mounted in screw holes designed for a second extruder - just remove and temporarily raise the layer fan\nTo level the bed manually, attach an LED light with its own battery to the switch and begin making adjustments.\nOnce you've tweaked the height of all the bed's screws, you'll only need to adjust the initial Z offset - this can be done once the switch is no longer present\nhttp://screenshots.ryotsuke.ru/scr_d40542441eed.png\nhttp://screenshots.ryotsuke.ru/scr_749dcb80b9be.png\nFor reference: a cherry switch should touch the buildplate at approximately Z7.0 and turn on at about Z6.5 or so