Overlap 25 2.5" FPV Cinewhoop Cinema Drone

thingiverse

Inspired by the Speedy Bee Flex25 this is my version of a 2.5" ducted cinema drone with overlapping props for a smaller 78mm wheelbase. This version uses a 16mm stack with the ESC mounted in the center and Flight Controller in the rear. If anyone is interested I can design a top plate to accommodate a 25mm Whoop AIO board. I print the duct in Ninja Tek Armadillo TPU and the top plate in Taulman 910 Nylon which makes for a really durable frame. The camera and antenna mounts are printed in regular TPU. My build: - Flight Controller: HGLRC FD413 16mm Stack - Motors: HGLRC Flame 1106 6000kv - VTX: HGLRC Zeus 350mw - RX: BetaFPV ELRS Lite w/flat antenna - Camera: Caddx Ant - Battery: 850mah 3S For my motors/setup I use 15mm Standoffs. My motors are 13mm height from the bottom of the mount to the top of the bell, if you are using a shorter motor you may have to add additional spacers under the motor for the props to clear the flight controller. The motor spacers are 2mm and 8mm if you want to do the math for your motors. The 16x16 plates are sized so that you can thread 2mm screws in without needed a backing nut. They are there to protect the boards in the event of a bent prop.