Over The Garden Wall Lantern

thingiverse

This is one of my first 3d design that i have fully printed, so sorry it its a little bad. After you have printed it you need to do a couple of thing. First you will need to make a cover for the lantern lid. So you will need a piece of what ever your using for the glass of the lantern.(i used paper) Place the paper on the backside of the lantern lid and press down on it with the lantern lid lip. This will seal the glass in place. Then you can connect the lid and the main body with the hinge and some wire. you will notice a loop and little cylinder and the right side of the lantern lid. This is to make sure the lid doesn't move. Place some wire around the cylinder and make a hook and the other end Put this though the loop and you should be done.