Oven control panel electronics case, Wujiang Sigmatron / 316222807

thingiverse

Did part of your oven break off? Was it some random plastic piece that holds the electronics for the control panel in place? It turns out that it's a crucial part, and you can't buy the plastic piece by itself anywhere. But you can easily print a new one super cheaply, because some random guy on the internet (me) created the model.\r\n\r\nPrint this using ABS, since it has a much higher glass transition temperature of around 105 degrees Celsius. If you use something with a lower glass transition temperature like PLA, which is about 65 degrees Celsius, the plastic will likely warp because it can get really hot near the control panel, depending on your oven model.