Out of Filament Sensor Mechanical
thingiverse
This thing was made with Tinkercad online at https://www.tinkercad.com/things/jXhnkHtti3T Out of filament, a mechanical switch (end stop) is used. It's small and compact with PTFE tube installation. You'll need to bend two small ends on the endstop as shown in the picture. First, do a trial fit on your box and make sure the end stop clicks when inserting or removing the filament. If done correctly, you can feed filament from either end. Just decide if you want wires going up or down. The Micro Switch XSS-5GL (SS-5GL) is used for CNC 3D Printer RepRap RAMPS; find it on eBay at http://www.ebay.com/itm/111977928485?_trksid=p2057872.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT You will also need two PC4-M6 Push to Connect Straight Fittings 4mm tubing, M6 6mm, 3D Printer etch; find them on eBay at http://www.ebay.com/itm/121485425862?_trksid=p2057872.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT You will also need two 3mm screws, each about 6-10mm long. Also needed is some wire with a length that suits your situation. Print Settings: Printer: Geeetech Prusa I3 aluminum Rafts: No Supports: No Resolution: .2 Infill: 20% Notes: This print was done in PETG, and it just happened to be in the printer when the decision was made to print.
With this file you will be able to print Out of Filament Sensor Mechanical with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on Out of Filament Sensor Mechanical.