osVAC NEO Adapter for AquaVac 1000

thingiverse

The AquaVac 1000 has its hose connected to the housing using just a press fit, you can easily pull it out when the vacuum isn't running. This Adapter sits in the same port and has an internal osVAC Neo F32 adapter to connect your hose to it.Note that the port in the AquaVac 1000 actually tapers off towards the inside. This Adapter has a diameter close to the inner end of the port, so that you can install it. I found that PLA was too rigid to properly sit in the port. Adding a 2cm wide strip of duct tape on the outside edge of the adapter adds enough flexibility to the part to reliably sit in the dust port, yet still be easy to pull out when you want to switch back to the original hose. If you want to or need to remix, here is the link to the Onshape document that created this part:https://cad.onshape.com/documents/db084aeb8521a2b65ee9e17d/w/bd30cb35836f148d7f2c818d/e/cf1a81b42e398a926aadaad3