Osmo Pocket Gimbal Caps

thingiverse

Easy to print snap-on cover designed specifically to protect the Osmo Pocket gimbal. Two versions are included for your convenience: Type A and Type B. Type A is a straightforward snap-on design that provides excellent protection without any hassle. On the other hand, Type B features a movable latch that allows you to close the cap with ease. The best part? It's entirely "print-in-place" and requires no additional parts to be assembled. This protective cap can also be used in conjunction with the protective case found on Thingiverse at https://www.thingiverse.com/thing:3364231. To get the best results, make sure to use the following print settings: - Layer height: 0.1 - 0.2mm - Supports are not required for Type A, but for Type B, use "Buildplate only" - Infill of at least 15% is recommended, and we suggest using "Cubic" as the infill type - Flow rate should be set to 110%