Orlandoo Hunter 2WD 4WD Transfercase

thingiverse

This is a 2WD 4WD servo switchable transfer case for Orlandoo vehicles. The motor plate I am using is the Tiny4x4 counter rotating axle transfer case. I'm sure one could easily design and print a plate to mimic; I haven't done that. For the intermediate gears, I used the 3d printed 11t gear with 2mm rod cut to length between. The gear slider is a 1.5mm steel rod. I used super glue to glue the slider to the rod. The output gears are 11t gears used in the transfer case of the M01, good luck finding these, I think I may have bought the last set. You may be able to use the 2mm shaft you bought and make your own output shafts, I'm not sure how that will go. I have the 2.2g servo mount that attaches to the transfer case, then there is another plastic mount for the shifter to allow a servo horn with a screw to push and pull the shifter. Note: You will need to be able to fine tune the endpoints of your shift servo, or you will put unnecessary binding on things.