original xbox prototype version 7

cults3d

I am still attempting to make a xbox prototype replica that matches well the original xbox prototype housed at microsoft head quarters. I want the original hardware to fit right, and make it look as much like the original as I can, while achieving proper airflow to keep the internals cool. on this version I had to extend my controller and power wires out nearly a foot so they can run to the back. I have it set up to use cerbios with no dvd, and where the dvd was originally planned to sit my hard drive will now sit. The design is now made for a 80mm noctual 5v fan set to 100% all the time in cerbios. will be print testing here in the next week or two. Versions 3 and 4 of some parts attempt to make them fit better. Updates for better fitment I have printed it and am pretty happy with it, I will update photos after some more post president but here are the as printed (not yet saved or painted) photos. Updated photos to show how I put it together better. I glued the power holder to the motherboard holder(mb1 v4), mounted the powersupply and motherboard, then attached the back (parts t2_2v4 and t2_1v4 glued together) by gluing to the mb/psu boards. Then I did my wiring and all that . I basically laid the x back on the ground and the board and such stood up, I slid parts (e_2 and e_1 glued together) over the top. Ideally you could screw them together but I put glue on mine :/ Hope that helps.