Original XBOX Display Stand

thingiverse

# Original XBOX Shelf Display Mount #### BEFORE PRINTING! Please check the screenshot of my Prusa Slicer to get the parts in the correct orientation - Thingiverse screwed the STL preview. This orientation removes the need for supports and prints them in the strongest way. #### Assembly Check the image above to show the mounting position on the XBOX. This is important to get a secure mount. You mount the stand into the grill below the front panel. The stand slots into the vent hole one after the filled in vent hole on each side (it's much easier to see the image). There is a left and right mount so make sure you get each side mounted correctly. The rectangle key should be facing outward left and outward right respectively from the XBOX. You can also put the 2 stand halves next to each other, they should be aligned (left and right) so the there's a smooth curve between them (this matches the curve on the bottom of the XBOX). When assembling, notice the rectangle key on the side of the 'A Frame'. This must line up the the corresponding rectangle key of the bottom part. Simply slide the bottom part to the A frame and super glue the two together. All weight is supported by the frame, the glue it just used to stop the bottom part from sliding out. #### Printing parts individually If you're printing the individual parts, look at the 'All Parts' STL for their proper printing orientation. They're placed in such a way for printing without supports. Super glue is required for welding the stands to the 'A Frame' parts. I have a V2 in the works that should remove the need for glue.