Original tile accessory sleeve (allows you to change battery on tile and keep using it)

prusaprinters

The original tile (T3001) was useless after the battery went dead because it did not allow you to easily change the battery as the case was glued together.   My solution was to print a sleeve that keeps the case intact, when you need to change the battery you just remove the tile from the sleeve change the battery and reinsert into the sleeve.  This allows you to keep the original tile body and have a protective sleeve that can slide on and off. Print SettingsSettingWalls2Layer Height0.2mmNozzle0.4mmMaterialAny filament will workInfill0%SupportsNoOtherPrint standing upright Instructions to use:You need an old tile where the battery has gone dead. Follow the instructions here on how to open the tile case and change batteryOnce battery is changed don't reglue the tile instead insert the tile into the printed sleeveNote: Depending on how dialed in your printer is you may need to scale this +/- a 1% for a tight fit.  Don't worry if the fit is really tight or a bit loose as the model has features to help you slide out the tile when you need to change the battery and the keyring will keep it intact if its loose.