Original Prusa Enclosure LED strip

prusaprinters

Of course you want LED strips in your Original Prusa Enclosure! I wanted them on the inside of the left, top and right front posts of the enclosure and attach them magnetically.  Since the Mk4 cannot print 400mm pieces, the brackets I designed are split and can be combined to create an arbitrary length with multiples of 200mmCombine two together, insert small 4mm round magnets (I used these) and place the 8mm wide LED strip in them. (So for LED strips on three sides, you need six brackets.)I soldered connectors on both sides of the LED strip, so I could easily mount them. The holes in the brackets will slide over the notches on the front posts where you normally attach tiewraps. The wires from the power supply are connected to the bottom of the left LED strip. The corner pieces in the picture are by BuildX