Original Prusa Enclosure Filament Passthrough

prusaprinters

<p>The bowden fitting is very firm, you might need to use players to push it in. If your print tolerances are a bit off. Use a 4mm drill to remove the excess from the print walls for the bowden fitting.</p><ul><li>Print it flat with no support.&nbsp;</li><li>Reuse the nylon rivets.&nbsp;</li><li>You will need about 45 - 50 cm long bowden tube.&nbsp;</li><li>print it as 0.15mm layer height it will take about 20 minutes.&nbsp;</li></ul><p>I have printed this in PLA however any other material can be used.&nbsp;</p>