Original CR10S Pro Hero Me ABL Mount Fix

thingiverse

I'm experiencing issues with the two abl mounts and new Hero Me Gen 4 files on my CR10S Pro. The end-stop won't trigger due to binding up against the end stop housing. Even if I remove material to clear it, the ABL ring hits the housing holding the end-stop and fails to trigger. To resolve this, I moved the ABL ring 10mm to the right, which shortened it enough for the end stop to trigger properly. This modification was specifically designed for a single 5015 fan duct, so further adjustments may be necessary with dual 5015 ducts. The blue mounts are causing the problem, while the black mount is intact in the pictures above. My calculations suggest that the probe offset should be (-44, -8, 0), based on where the stock mount was and my measurements of the sensor's new position.