Organizer for Metric Tap, Drill and Die

thingiverse

This organizer is designed specifically for use with the Dewalt 17 piece metric tap/die set, but it should also work effectively with standard metric taps and matching drill bits and dies. It holds M3, M4, M5, M6, and M7 taps and dies, along with matching drill bits for the taps, a 1/4" tap handle, and a 5/8" die handle. The design was inspired by tom7's SAE version, but it has been modified to be slightly more compact. The layout is essentially the same as the original, but it now stores the info card in the back of the organizer. One note about the design: the hole for the 7mm tap drill bit is a bit too small, so you may need to insert the drill cutting side down and spin it by hand a few times to get it through. Print Settings: Infill: 20% Notes: Dimensions are optimized for use with a .4mm nozzle and .2mm print height. A moderate infill level is required to provide adequate support for the bottoms of the die holders, as all other holes reach down to the bottom.